METER LOOP SPECIFICATIONS/ELECTRICAL WIRING

The specifications listed below are for up to 200 AMP service only. Please contact the Engineering Department at 979-968-3181 or 1-866-968-3181 for service over 200 AMP.

The meter shall be located on the outside of the structure, not inside of any structure.

Electric service will be connected only after the wiring of the meter loop has been inspected and approved by FEC personnel.  If the wiring is not approved, the owner (or contractor) will make all necessary changes to the wiring to make it conform and agrees to notify FEC when the changes are complete.

FEC may decline service to any Member if the installation or equipment is known to be hazardous or of such condition that satisfactory service cannot be provided.

FEC accepts no responsibility and assumes no liability for the adequacy of the Member’s installation or for damages and/or injury as a result of inadequate apparatus or equipment, incorrect wiring, faulty material or workmanship, or any other deficiencies or defects in the wiring and/or equipment on the Member’s premises.

Member agrees that Member’s installation, including all conductors, switches, equipment, wiring and protective devices of any kind, is constructed and will be operated and maintained in a safe manner and in accordance with any and all applicable laws, ordinances, or policies of Fayette Electric Cooperative, the National Electrical Code and the National Electrical Safety Code and all applicable government requirements.